HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Installing and Configuring the HSG Agent
145HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
9. Select one of the following for your access privileges: overall status, detailed
status, and configuration. The access privilege level controls the client
system's level of access to the storage subsystems. The following explains the
client system access options:
10. Click Add Client to add the client system entry to the Client list. For more
information on adding, deleting, or modifying a Client, See “You can move a
storageset from one subsystem to another without destroying its data. You
also can follow the steps in this section to move a storageset to a new location
within the same subsystem.” on page 201.
11. Click Next to continue. If the Windows NT Agent Configuration Step 3 of 3
window appears, go to step 13.
If you had previously added a subsystem, the following message appears:
A previous storage list is detected. Would you like to scan the
subsystem to update the information? The subsystem names will
revert to default settings.
If you click Ye s, the software will automatically add entries for the new
subsystems and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The Windows NT Agent Configuration Step 3 of 3 window appears.
12. The configuration wizard should have created an entry for the subsystems
attached to this system. To modify the name or other settings for a subsystem,
see You can change the configuration you created when you installed the
Agent by using the HS Series Agent Configurator, which can be accessed from
the Start menu. presented in the next section.
13. Click Finish. A message, warning you to restart your Agent, appears.
Table 15: Client System Access Options
Options SWCC Function
Overall Status Can use the Client to add a system to a Navigation Tree, set
up a pager, and view properties of the controller and the
system
Cannot use Client to open a Storage Window
Detailed Status Can use the Client to open a Storage Window, but you
cannot make modifications in that window
Configuration Can use the Client to make changes in a Storage Window
to modify a subsystem configuration