HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Installing and Configuring the HSG Agent
150 HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
6. Click Finish. The following message appears:
No subsystem information was added to the subsystem list.
Subsystem list will not be created or modified.
7. Click OK. The Welcome NT Agent Configuration Utility window appears.
8. Click Exit to quit the NT Agent Configuration Utility.
9. You must stop and restart the Agent for your changes to take effect. For
instructions, see “Stopping and Starting the Agent” on page 153.
Adding a Subsystem Entry
You must tell the Agent which subsystems to monitor.
Caution: Verify that you have the correct communication drive before you
manually add a subsystem.
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click Next to continue. You do not need to enter your password. The NT
Agent Configuration Step 2 of 3 window appears.
4. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window
appears, go to step 5.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the
subsystem to update the information? (Subsystem names will
revert to default settings.)
If you click Ye s, the software will automatically add entries for the new
subsystems and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.