HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Installing and Configuring the HSG Agent
151HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
5. Enter the name of the subsystem in the Selected Subsystem field. Enter the
communication drive letter and monitoring interval in seconds. The
monitoring interval is the rate at which the Agent queries the specified
subsystem for status. A reasonable monitoring interval in seconds would be
120.
When you select Subsystem Enabled, the subsystem is included in the Agent’s
scans. When Subsystem Enabled is selected, the software configures the
storage.ini file so that the subsystem selected in the dialog box is visible to the
host. The storage.ini file holds information about the RAID devices connected
to your server.
6. Click Add Subsystem. The name of the added subsystem appears in the
Storage Subsystems field.
7. Click Finish. A message, warning you to restart your Agent, appears.
8. Click OK. You exit the NT Agent Configuration Utility.
9. You must stop and restart the Agent for your changes to take effect. For
instructions, see “Stopping and Starting the Agent” on page 153.
Modifying a Subsystem Entry
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click Next to continue. You do not need to enter your password. The NT
Agent Configuration Step 2 of 3 window appears.
4. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window
appears, go to step 5.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the
subsystem to update the information? (Subsystem names will
revert to default settings.)
If you click Ye s, the software will automatically add entries for the new
subsystems and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.