HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

Installing and Configuring the HSG Agent
152 HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
5. Select the subsystem that you want to modify in the Subsystems field. You
may change the communication drive letter, the monitoring interval, and the
subsystem’s name. The monitoring interval is the rate at which the Agent
queries the specified subsystem for status. A reasonable monitoring interval in
seconds would be 120.
When you select Subsystem Enabled, the subsystem is included in the Agent’s
scans. When Subsystem Enabled is selected, the subsystem is visible in the
Client GUI.
When you select the subsystem, the following properties are shown: controller
enter, devices, EMU enter, firmware version, serial number of controller 1,
serial number of controller 2, and total number of devices.
6. Click Modify Subsystem to confirm your changes.
7. Click Finish. A message, warning you to restart your Agent, appears.
8. Click OK. You exit the NT Agent Configuration Utility.
9. You must stop and restart the Agent for your changes to take effect. For
instructions, see “Stopping and Starting the Agent” on page 153.
Deleting a Subsystem Entry
When you delete a subsystem entry, the Agent stops monitoring that subsystem.
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click
Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click
Next to continue. You do not need to enter your password. The NT
Agent Configuration Step 2 of 3 window appears.
4. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window
appears, go to step 5.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the
subsystem to update the information? (Subsystem names will
revert to default settings.)
If you click Yes, the software will automatically add entries for the new
subsystems and restore default subsystem information for the existing entries.
Or
If you click
No, the software will keep the current settings.