HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

FC Configuration Procedures
182 HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
For example, the following command changes the replacement policy for
RAIDset RAID1 to BEST_FIT:
SET RAID1 POLICY=BEST_FIT
Changing Device Switches
Use the SET device-name command to change the device switches.
For example, to request a data transfer rate of 20 MHz for DISK10000:
SET DISK10000 TRANSFER_RATE_REQUESTED=20MHZ
Changing Initialize Switches
The initialization switches cannot be changed without destroying the data on the
storageset or device. These switches are integral to the formatting and can only be
changed by reinitializing the storageset. Initializing a storageset is similar to
formatting a disk drive; all data is destroyed during this procedure.
Changing Unit Switches
Use the SET unit-name command to change the characteristics of a unit.
For example, the following command enables write protection for unit D100:
SET D100 WRITE_PROTECT