HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

183HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server

2003 (32-bit) Installation and Configuration Guide

Using CLI for Configuration

This chapter presents an example of how to configure a storage subsystem using

the Command Line Interpreter (CLI). The CLI configuration example shown

assumes:

■ A normal, new controller pair, which includes:

— NODE ID set

— No previous failover mode

— No previous topology set

■ Full array with no expansion cabinet

■ PCMCIA cards installed in both controllers

A storage subsystem example is shown in Figure 42. The example system

contains three non-clustered WINNT hosts, as shown in Figure 45. From the

hosts’ point of view, each host will have four paths to its own virtual disks. The

resulting virtual system, from the host’s point of view, is shown in Figure 45.