HP StorageWorks HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Installation and Configuration Guide (AA-RV1XA-TE, March 2005)

FC Configuration Procedures
178 HSG80 ACS Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server
2003 (32-bit) Installation and Configuration Guide
Preferring Units
In multiple-bus failover mode, individual units can be preferred to a specific
controller. For example, to prefer unit D102 to “this controller,” use the following
command:
SET D102 PREFERRED_PATH=THIS
RESTART commands must be issued to both controllers for this command to take
effect:
RESTART OTHER_CONTROLLER
RESTART THIS_CONTROLLER
Note: The controllers need to restart together for the preferred settings to take effect.
The RESTART this_controller command must be entered immediately after the
RESTART other_controller command.
Configuration Options
Changing the CLI Prompt
To change the CLI prompt, enter a 1- to 16-character string as the new prompt,
according to the following syntax:
SET THIS_CONTROLLER PROMPT = “NEW PROMPT”
If you are configuring dual-redundant controllers, also change the CLI prompt on
the “other controller.” Use the following syntax:
SET OTHER_CONTROLLER PROMPT = “NEW PROMPT”
Note: It is suggested that the prompt name reflect some information about the
controllers. For example, if the subsystem is the third one in a lab, name the top
controller prompt, LAB3A and the bottom controller, LAB3B.
Mirroring cache
To specify mirrored cache, use the following syntax:
SET THIS MIRRORED_CACHE