Fabric OS Administrator's Guide v7.0.0 (53-1002148-02, June 2011)

162 Fabric OS Administrator’s Guide
53-1002148-02
Policy database distribution
7
Managing filter thresholds
Fabric OS v7.0.0 allows you to configure filter thresholds using the fmMonitor command.
1. Connect to the switch and log in using an account with admin permissions, or an account with
OM permissions for the FabricWatch RBAC class of commands.
2. Enter the fmMonitor command.
Example of fmMonitor command:
admin> fmMonitor -–create ex1 -pat 12,0xFF,0x08 -port 2/1-2,8/3 -highth
1000 - action snmp,raslog –timebase minute
Policy database distribution
Fabric OS lets you manage and enforce the ACL policy database on either a per-switch or
fabric-wide basis. The local switch distribution setting and the fabric-wide consistency policy affect
the switch ACL policy database and related distribution behavior.
The ACL policy database is managed as follows:
• Switch database distribution setting — Controls whether or not the switch accepts or rejects
databases distributed from other switches in the fabric. The distribute command sends the
database from one switch to another, overwriting the target switch database with the
distributed one. To send or receive a database the setting must be accept. For configuration
instructions, see “Database distribution settings” on page 163.
Virtual Fabric considerations: FCS, DCC, SCC, and AUTH databases can be distributed using
the -distribute command, but the PWD and IPFILTER databases are blocked from distribution.
• Manually distribute an ACL policy database — Run the distribute command to push the local
database of the specified policy type to target switches. “ACL policy distribution to other
switches” on page 164.
• Fabric-wide consistency policy — Use to ensure that switches in the fabric enforce the same
policies. Set a strict or tolerant fabric-wide consistency policy for each ACL policy type to
automatically distribute that database when a policy change is activated. If a fabric-wide
consistency policy is not set, then the policies are managed on a per switch basis. For
configuration instructions, see “Fabric-wide enforcement” on page 165.
Virtual Fabric considerations: Fabric-wide consistency policies are configured on a per logical
switch-basis and are applied to the fabrics connected to the logical switches. Automatic policy
distribution behavior for DCC, SCC and FCS is the same as that of pre-v6.2.0 releases and are
configured on a per logical switch basis.
Table 37 on page 163 explains how the local database distribution settings and the fabric-wide
consistency policy affect the local database when the switch is the target of a distribution
command.