Fabric OS Administrator's Guide v7.0.0 (53-1002148-02, June 2011)

228 Fabric OS Administrator’s Guide
53-1002148-02
Disabling Virtual Fabrics mode
10
3. Delete all Admin Domains, as described in “Deleting all user-defined Admin Domains
non-disruptively” on page 356.
4. Enter the following command to enable VF mode:
fosconfig --enable vf
5. Enter y at the prompt.
Example
The following example checks whether VF mode is enabled or disabled and then enables it.
switch:admin> fosconfig --show
FC Routing service: disabled
iSCSI service: Service not supported on this Platform
iSNS client service: Service not supported on this Platform
Virtual Fabric: disabled
Ethernet Switch Service: Service not supported on this Platform
switch:admin> fosconfig --enable vf
WARNING: This is a disruptive operation that requires a reboot to take
effect.
All EX ports will be disabled upon reboot.
Would you like to continue [Y/N] y
VF has been enabled. Your system is being rebooted.
Disabling Virtual Fabrics mode
When you disable VF mode, the following occurs:
The CPs are rebooted.
If F_Port trunking is enabled on ports in the default switch, the F_Port trunking information is
deleted.
If you want to use Admin Domains in a fabric, you must first disable VF mode.
1. Connect to the physical chassis and log in using an account with the chassis-role permission.
2. Enter the following command to check whether VF mode is disabled:
fosconfig --show
3. Move all ports to the default logical switch.
lscfg --config 128 -slot slot -port port
4. Delete all of the non-default logical switches.
lscfg --delete fabricID
5. Enter the following command to disable VF mode:
fosconfig --disable vf
6. Enter y at the prompt.