Fabric OS Administrator's Guide v7.0.0 (53-1002148-02, June 2011)

Fabric OS Administrator’s Guide 23

53-1002148-02

The Ethernet interface on your switch

4. Enter the Ethernet Subnetmask at the prompt.

5. Skip the Fibre Channel prompts by pressing Enter.

The Fibre Channel IP address is used for management.

6. Enter the Gateway Address at the prompt.

7. Disable DHCP by entering off.

Setting the static addresses for the chassis management IP interface

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ipAddrSet -chassis command.

switch:admin> ipaddrset -chassis

Ethernet IP Address [192.168.166.148]:

Ethernet Subnetmask [255.255.255.0]:

Committing configuration...Done.

3. Enter the network information in dotted-decimal notation for the Ethernet IPv4 address or in

semicolon-separated notation for IPv6.

4. Enter the Ethernet Subnet mask at the prompt.

DHCP activation

By default, some Brocade switches have DHCP enabled.

NOTE

The Brocade DCX and Brocade DCX-4S enterprise-class platforms do not support DHCP.

The Fabric OS DHCP client supports the following parameters:

• External Ethernet port IP addresses and subnet masks

• Default gateway IP address

The DHCP client uses a DHCP vendor-class identifier that allows DHCP servers to determine that

the discover/request packet are coming from a Brocade switch. The vendor-class identifier is the

string “BROCADE” followed by the SWBD model number of the platform. For example, the

vendor-class identifier for a request from a Brocade 5300 is “BROCADESWBD64.”

NOTE

The client conforms to the latest IETF Draft Standard RFCs for IPv4, IPv6, and DHCP.

Enabling DHCP

Connect the DHCP-enabled switch to the network, power on the switch, and the switch

automatically obtains the Ethernet IP address, Ethernet subnet mask, and default gateway address

from the DHCP server. The DHCP client can only connect to a DHCP server on the same subnet as

the switch. Do not enable DHCP if the DHCP server is not on the same subnet as the switch.

Enabling DHCP after the Ethernet information has been configured releases the current Ethernet

network interface settings, including Ethernet IP address, Ethernet subnet mask, and gateway IP

address. The Fibre Channel IP address and subnet mask are static and are not affected by DHCP;

for instructions on setting the FC IP address, see “Static Ethernet addresses” on page 22.