HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

26 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR

 A standard electronic environment where the ambient temperature is between 10º

and 35º C (50º F and 95º F) and the relative humidity is between 10% and 90%

(non-condensing). For detailed information, see Appendix A, “Status Lights,

Technical Specifications, and Regulatory Information.”

 Ethernet connections available within the standard Ethernet limit.

 Space on a two or four post 19-inch rack.

 A clean power source dedicated to computer devices and other electronic

equipment.

Required Tools and Equipment

You need the following tools and equipment to mount the HP EFS WAN Accelerator

to a rack:

 A standard 19-inch Telco-type mounting rack. The HP ProLiant DL380-3010

and DL380-5010 require 2 Units (U) of rack space. The HP ProLiant DL320-

520, DL320-1020, and DL320-2020 require 1 U of rack space.

 Appropriate screwdriver for screws if mounting into a threded-hole rack. Refer

to the instructions that came with the rack mount kit. Also refer to the

documentation that came with your system for important rack planning resource

instructions.

NOTE: If mounting a two-post rack, go to http://www.racksolutions.com/hp.

Completing the Configuration Checklist

Before you begin, consult the Rack Installation Guide for detailed information about

how to install your model to a rack.

The following checklist lists the parameters you specify to complete the initial

configuration of the HP EFS WAN Accelerator. Be prepared to provide values for the

parameters listed in the following checklist