HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 31

2 - INSTALLING AND

ONFIGURING THE HP EFS

Only one type of card is allowed in the system. Up to two of the HP EFS N2c WAN

Accelerator 2-port NIC or HP EFS N2f WAN Accelerator 2-port NIC bypass cards

are allowed in the system. Up to three four-port copper Gig-E bypass cards are

allowed in the system.

Therefore, the allowable configurations are:

1- or 2- HP EFS N2c WAN Accelerator 2-port NIC

1- or 2- HP EFS N2f WAN Accelerator 2-port NIC

1-, 2-, or 3- HP EFS N4c WAN Accelerator 4-port NIC

NIC Port LabelingTerminology Note

Labeling for the NIC ports can vary. To avoid confusion, the table below outlines the

different labels for the NIC ports.

Powering On the HP EFS WAN Accelerator

The following section describes how to connect the Alternating Current (AC) power

and how to power on the HP EFS WAN Accelerator.

WARNING: Ensure that the HP EFS WAN Accelerator is properly grounded. See the HP

ProLiant DL320 Generation 4 Server User Guide or the HP ProLiant DL380 Generation 4

Server Reference and Troubleshooting Guide for more information on grounding.

To power on the HP

ProLiant DL320-520,

DL320-1020, and

DL320-2020

1. Plug the AC power cord into the HP EFS WAN Accelerator (Figure 2-4 on page

29, item 3).

2. Plug the AC power cord into an uninterrupted AC power source .

3. Press the Power On/Standby button on the front of the HP EFS WAN Accelerator

(Figure 5-1 on page 63, item 6).

4. Check the status lights on the front and rear of the HP EFS WAN Accelerator

(Figure 5-1 on page 63).

Location Label 1 Label 2

In documentation, Command Line interface, and graphical

user interface

Primary AUX

HP ProLiant DL320-520, DL320-1020, and DL320-2020 NIC1 NIC2

HP ProLiant DL380-3010 and DL380-5010 1 2