HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

32 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR
To power on the HP
ProLiant DL380-3010
and DL380-5010
1. Plug the AC power cords into the HP EFS WAN Accelerator (Figure 2-5 on page
30, item 7).
2. Plug the AC power cords into an uninterrupted AC power source.
3. Press the Power On/Standby button on the front of the HP EFS WAN Accelerator
(Figure 5-2 on page 65, item 6).
4. Check the status lights on the front and rear of the HP EFS WAN Accelerator
(Figure 5-2 on page 65).
NOTE: The disk drives take about 2-5 minutes to boot.
HP System Management Homepage v2.0
The HP System Management Homepage v2.0 is a web-based interface that
consolidates and simplifies the management of HP ProLiant servers. It provides a
secure and intuitive interface to review in-depth hardware configuration and status
data, performance metrics, system thresholds and software version control
information. Go to the
HP System Management Homepage v2.0 for more information.
Integrated Lights-Out
The Integrated Lights-Out (iLO) feature allows remote server management. Refer to
the Integrated Lights-Out User Guide that came with the documentation set CD-ROM
for your product.
Connecting to the HP EFS WAN Accelerator
To access the configuration wizard and the HP EFS WAN Accelerator command-line
interface (CLI), you establish a serial connection using a terminal emulator program.
To connect to the HP
StorageWorks
Enterprise File
Services WAN
Accelerator
1. Plug the serial cable into the Console port and a terminal.
 For the HP ProLiant DL320-520, DL320-1020, and DL320-2020, refer to
refer to Figure 2-4 on page 29, item 8.
 For the HP ProLiant DL380-3010 and DL380-5010, refer to Figure 2-5 on
page 30, item 4.
TIP: You can also connect to the HP EFS WAN Accelerator using a cross-over cable. Plug a
cross-over cable into the NIC1 (Primary) port of the HP EFS WAN Accelerator and your laptop
computer. If you use this method, you will be disconnected after changing the primary default
IP address (169.254.169.254) in the configuration wizard. You must reconnect using the new IP