HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 33

2 - INSTALLING AND

ONFIGURING THE HP EFS

address that you entered and restart the configuration wizard using the configuration jump-

start command in the CLI.

2. Start your terminal emulation program, such as Terra Term Pro. The terminal

device must have the following settings:

 Baud rate: 9600 bps

 Data bits: 8

 Parity: none

 Stop bits: 1

 vt100 emulation

 No flow control

NOTE: If you are using the HP EFS WAN Accelerator with a terminal server, the terminal

server must use hardware flow control for the port connected to the HP EFS WAN Accelerator.

3. Log in as administrator user (admin) and enter the default password (password).

For example:

Sent username "admin"

password: password

4. Check the system and disk drive status lights.

 For the HP ProLiant, refer to DL320-520, DL320-1020, and DL320-2020,

refer to Figure 5-1 on page 63.

 For the HP ProLiant DL380-3010 and DL380-5010, refer to Figure 5-2 on

page 65.

NOTE: For Bypass card status lights, see “Bypass Card Status Lights” on page 66

After you have established connection, you configure the HP EFS WAN Accelerator

using the configuration wizard:

 For in-path configurations, see “Configuring In-Path HP EFS WAN

Accelerators,” next.

 For out-of-path configurations, see “Configuring Out-of-Path HP EFS WAN

Accelerators” on page 41.