HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)
HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 35
2 - INSTALLING AND
C
ONFIGURING THE HP EFS
Do you want to auto-configure using a CMC? no
If you answer yes, you are prompted for the HP EFS WAN Accelerator Manager
host name or IP address. The host name or IP address is used to contact the HP
EFS WAN Accelerator Manager. The default value is set to hpwam. If you enter
no, the wizard continues.
TIP: If you mistakenly answer yes, to return to the wizard from the CLI, enter the
configuration jump-start command from configuration mode. For detailed information, see the
“To restart the configuration wizard” on page 34.
2. To start the configuration wizard, enter yes at the system prompt. For example:
Do you want to use the configuration wizard for initial configuration?
yes
3. Complete the configuration wizard steps on the client-side and server-side HP EFS
WAN Accelerators as described in the following table.
Wizard Prompt Description Example
Step 1: Hostname? Enter the host name for the HP EFS WAN
Accelerator Manager
.
Step 1: Hostname? minna
Step 2: Use DHCP on the primary
interface?
You are given the option to enable the
Dynamic Host Configuration Protocol
(DHCP) to automatically assign an IP
address to the primary interface for the HP
EFS WAN Accelerator.
HP recommends that you do not set
DHCP.
The default value is no.
Step 2: Use DHCP? no
Step 3: Primary IP address? Enter the IP address for the HP EFS WAN
Accelerator.
Step 3: Primary IP address?
10.10.10.6
Step 4: Netmask? Enter the netmask address.
Step 4: Netmask? 255.255.0.0
Step 5: Default gateway? Enter the default gateway for the HP EFS
WAN Accelerator.
Step 5: Default gateway?
10.0.0.1
Step 6: Primary DNS server? Enter the primary DNS server IP address.
Step 6: Primary DNS server?
10.0.0.2
Step 7: Domain name? Enter the domain name for the network on
which the HP EFS WAN Accelerator is to
reside.
If you set a domain name, you can enter
host names in the system without the
domain name.
Step 7: Domain name? example.com
Step 8: Admin password? HP strongly recommends that you change
the default administrator password at this
time. The password must be minimum of
6 characters.
The default administrator password is
password.
Step 8: Admin password? xxxyyy