HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

36 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR
Step 9: SMTP server? Enter the SMTP server. External DNS and
external access for SMTP traffic is
required for email notification of events
and failures to function.
IMPORTANT: Make sure you provide a
valid SMTP server to ensure email
notifications for events and failures.
Step 9: SMTP server? [natoma]
Step 10: Notification email address? Enter a valid email address to receive
email notification of events and failures.
Step 10: Notification email
address? [[e-mail]]
Step 11: Set the primary interface
speed?
Enter the speed on the primary interface
(that is, the HP EFS WAN Accelerator).
Make sure this value matches the settings
on your router or switch.
The default value is auto.
Step 11: Set the primary
interface speed? [auto] auto
Step 12: Set the primary interface
duplex?
Enter the duplex mode on the primary
interface, type a value at the system
prompt. Make sure this value matches the
settings on your router or switch. The
default value is auto.
Step 12: Set the primary
interface duplex? [auto] auto
Step 13: Would you like to activate
the in path configuration?
Enter yes at the system prompt to
configure in-path support. An in-path
configuration is a configuration in which
the HP EFS WAN Accelerator is in the
direct path of the client and server.
For detailed information about in-path
configurations, see the HP EFS WAN
Accelerator Deployment Guide.
Step 13: Would you like to
activate the in path
configuration? yes
Step 14: In Path IP address? Enter the in-path IP address for the HP
EFS WAN Accelerator.
Step 14: In-Path IP address?
[10.11.11.6]