HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

40 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR
NOTE: Alternatively, you can specify the IP address instead of the host and domain. For
example: http://169.254.169.254/.
The Management Console appears, displaying the Welcome page.
Figure 2-7. Welcome Page
2. In the Account text box, type the user login: admin, monitor, a login from a
Remote Authentication Dial-In User Service (RADIUS), or a Terminal Access
Controller Access Control System (TACACS+) database. The default login is
admin.
Users with administrator (admin) privileges can configure and administer the HP
EFS WAN Accelerator. Users with monitor (monitor) privileges can view
connected HP EFS WAN Accelerators, reports, and system logs.
3. In the Password text box, type the password you assigned in the configuration
wizard.
4. Click Login to display the Home: Welcome page. The Home: Welcome page
summarizes the current status of your system and provides links to connected HP
EFS WAN Accelerators, a traffic summary, alarms, system logs, and HP technical
support information.
Verifying Your
Configuration
Perform the following tasks to verify that you have properly configured the HP EFS
WAN Accelerator.
If you selected auto-negotiation (auto) for your in-path and primary interfaces, you
must make sure that the HP EFS WAN Accelerator negotiated the speed and duplex at
the rate that your devices expect. For example, ensure settings are auto on the LAN
and WAN and 100 FULL on the LAN and WAN. You can verify your speed and
duplex settings in the Setup: Networking - In-Path (LAN/WAN) Interface page of the
Management Console.