HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

42 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR
To configure the
server-side HP
EFS WAN
Accelerator in an
out-of-path
deployment
1. If you have a HP StorageWorks Enterprise File Services WAN Accelerator
Manager (HP EFS WAN Accelerator Manager) appliance installed in your
network to manage multiple HP EFS WAN Accelerators you can use it to
automatically configure them.
Do you want to auto-configure using a CMC? no
If you enter yes, you are prompted for the HP EFS WAN Accelerator Manager
host name or IP address. The host name or IP address is used to contact the HP
EFS WAN Accelerator Manager. The default value is set to hpwam. If you enter
no, the wizard continues.
TIP: If you mistakenly answer yes, to return to the wizard from the CLI, enter the
configuration jump-start command from configuration mode. For detailed information, see the
“To restart the configuration wizard” on page 34.
2. To start the configuration wizard, enter yes at the system prompt. For example:
Do you want to use the configuration wizard for initial configuration?
yes
TIP: If you mistakenly answer no, to return to the wizard from the CLI, enter the configuration
jump-start command from configuration mode. For detailed information, see the “To restart the
configuration wizard” on page 34.
3. Complete the configuration wizard steps on the client-side and server-side.
Wizard Prompt Description Example
Step 1: Hostname? Enter the host name for the HP EFS WAN
Accelerator Manager
.
Step 1: Hostname? minna
Step 2: Use DHCP on the primary
interface?
You are given the option to enable the
Dynamic Host Configuration Protocol
(DHCP) to automatically assign an IP
address to the primary interface for the HP
EFS WAN Accelerator.
HP recommends that you do not set
DHCP.
The default value is no.
Step 2: Use DHCP? no
Step 3: Primary IP address? Enter the IP address for the HP EFS WAN
Accelerator.
Step 3: Primary IP address?
10.10.10.6
Step 4: Netmask? Enter the netmask address.
Step 4: Netmask? 255.255.0.0
Step 5: Default gateway? Enter the default gateway for the HP EFS
WAN Accelerator.
Step 5: Default gateway?
10.0.0.1
Step 6: Primary DNS server? Enter the primary DNS server IP address.
Step 6: Primary DNS server?
10.0.0.2