HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 43
2 - INSTALLING AND
C
ONFIGURING THE HP EFS
Step 7: Domain name? Enter the domain name for the network on
which the HP EFS WAN Accelerator is to
reside.
If you set a domain name, you can enter
host names in the system without the
domain name.
Step 7: Domain name? example.com
Step 8: Admin password? HP strongly recommends that you change
the default administrator password at this
time. The password must be minimum of
6 characters.
The default administrator password is
password.
Step 8: Admin password? xxxyyy
Step 9: SMTP server? Enter the SMTP server. External DNS and
external access for SMTP traffic is
required for email notification of events
and failures to function.
IMPORTANT: Make sure you provide a
valid SMTP server to ensure email
notifications for events and failures.
Step 9: SMTP server? natoma
Step 10: Notification email address? Enter a valid email address to receive
email notification of events and failures.
Step 10: Notification email
address? [e-mail]
Step 11: Set the primary interface
speed?
Enter the speed on the primary interface
(that is, the HP EFS WAN Accelerator).
Make sure this value matches the settings
on your router or switch.
The default value is auto.
Step 11: Set the primary
interface speed? [auto] auto
Step 12: Set the primary interface
duplex?
Enter the duplex mode on the primary
interface, type a value at the system
prompt. Make sure this value matches the
settings on your router or switch. The
default value is auto.
Step 12: Set the primary
interface duplex? [auto] auto
Step 13: Would you like to activate
the in path configuration?
Enter no at the system prompt to
configure in-path support. An in-path
configuration is a configuration in which
the HP EFS WAN Accelerator is in the
direct path of the client and server.
For detailed information about in-path
configurations, see the HP EFS WAN
Accelerator Deployment Guide.
Step 13: Would you like to
activate the in path
configuration? no
Step 14: Would you like to activate
the out-of-path configuration?
Enter yes at the system prompt to
configure out-of-path support. An out-of-
path configuration is a configuration in
which the HP EFS WAN Accelerator is
not in the direct path of the client and
server.
For detailed information about in-path
configurations, see the HP EFS WAN
Accelerator Deployment Guide.
Step 14: Would you like to
activate the out-of-path
configuration? [no] yes