HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

44 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR

The system confirms your settings.

You have entered the following information:

Step 1: Hostname? minna

Step 2: Use DHCP on primary interface? no

Step 3: Primary IP address? 10.10.10.6

Step 4: Netmask? 255.255.0.0

Step 5: Default gateway? 10.0.0.1

Step 6: Primary DNS server? 10.0.0.2

Step 7: Domain name? mydomain.com

Step 8: Admin password? xxxyyyy

Step 9: SMTP server? natoma

Step 10: Notification email address? example@example.com

Step 11: Set the primary interface speed? auto

Step 12: Set the primary interface duplex? auto

Step 13. Would you like to activate the in-path configuration: no

Step 14: Would you like to activate the out-of-path configuration? yes

To change an answer, enter the step number to return to.

Otherwise hit <enter> to save changes and exit.

The HP EFS WAN Accelerator configuration wizard automatically saves your

configuration settings.

4. To log out of the system, enter the following command at the system prompt:

minna> exit

Connecting the

HP EFS WAN

Accelerator to

Your Network

You use a CAT-5E straight-through cable to connect the Primary port of the HP EFS

WAN Accelerator to the LAN switch in an out-of-path configuration.

To connect the HP EFS

WAN Accelerator to

your network

• Plug the straight-through cable into the NIC1 (Primary) port of the HP EFS WAN

Accelerator and the LAN switch. This can be any port on your LAN switch which

is configured to connect to a host.

 For the HP ProLiant DL320-520, DL320-1020, and DL320-2020, refer to

Figure 2-4 on page 29, item 6.

 For the HP ProLiant DL380-3010 and DL380-5010, refer to Figure 2-5 on

page 30, item 9.

For detailed information about the Management Console, see the HP Enterprise File

Services WAN Accelerator Management Console user guide.

For detailed information about the CLI, see the HP Enterprise File Services WAN

Accelerator Command-Line Interface reference manual.

The following procedures describe how to configure in-path rules using the

Management Console.