HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 installation and configuration guide (AG424-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 45
2 - INSTALLING AND
C
ONFIGURING THE HP EFS
To configure the client-
side HP StorageWorks
Enterprise File
Services WAN
Accelerator
1. Follow the procedures for an in-path configuration. For details, see “Configuring
In-Path HP EFS WAN Accelerators” on page 34.
2. Connect to the Management Console. For details, see “Connecting to the HP EFS
WAN Accelerator” on page 39.
3. Navigate to the Setup: Optimization Service - In-Path Rules page.
Figure 2-8. Setup: Service - In-Path Rules Page
4. Under Add New Rule, select Fixed-Target from the Type drop-down list.
5. Under Targets, type the IP address and port number for the HP EFS WAN
Accelerator that is the peer in the Target IP and Port text boxes. The IP address
must be the Primary Port IP address on the target HP EFS WAN Accelerator. The
default port is 7810.