HP StorageWorks Enterprise File Services WAN Accelerator Deployment Guide (November 2005)

104 9 - RADIUS AND TACACS+ AUTHENTICATION
Basic Steps The following section describes the basic steps for configuring TACACS+
authentication in the HP EFS WAN Accelerator.
1. Configure the HP EFS WAN Accelerator. For detailed information, see the
HP EFS WAN Accelerator Installation and Configuration Guide.
2. Connect to the Management Console. For detailed information, see the HP
EFS WAN Accelerator Installation and Configuration Guide.
3. Navigate to the Setup: Authentication - General Settings page in the
Management Console.
4. Define the authentication methods. Make sure you put the authentication
methods in the order in which you want them to occur. If authorization
fails on the first method, the next method is attempted, and so forth, until
all the methods have been attempted.
Figure 9-3. Setup: Authentication - General Settings Page
5. Navigate to the Setup: Authentication - TACACS+ Servers page.