HP StorageWorks Enterprise File Services WAN Accelerator Deployment Guide (November 2005)

HP EFS WAN ACCELERATOR DEPLOYMENT GUIDE 21
2 - IN-PATH DEPLOYMENTS
CHAPTER 2 In-Path Deployments
In This Chapter This chapter describes physical in-path network deployments and
summarizes the basic steps for configuring them. This chapter includes the
following sections:
 “Introduction to Physical In-Path Deployments,” next
 “In-Path, Failover Support Deployment” on page 22
 “In-Path, Two Routing Points Deployment” on page 24
 “In-Path, Server-Side Deployment” on page 25
 “In-Path, Server-Side, One to One Deployment” on page 27
This chapter assumes that you are familiar with the HP EFS WAN Accelerator
Management Console (Management Console). For detailed information about
the Management Console and how to use it, see the HP EFS WAN Accelerator
Management Console User Guide.
This chapter also assumes that you are familiar with the installation and
configuration process for the HP EFS WAN Accelerator. For detailed
information, see the HP EFS WAN Accelerator Installation and Configuration
Guide.
This chapter provides the basic steps for physical in-path network
deployments. It does not provide detailed procedures. Use this chapter as a
general guide for these deployments. If you need additional assistance, contact
HP technical support at http://www.hp.com.
For detailed information about the factors you must consider before you
deploy the HP EFS WAN Accelerator, see “Design and Deployment
Overview” on page 15.