HP StorageWorks Enterprise File Services WAN Accelerator Deployment Guide (November 2005)

HP EFS WAN ACCELERATOR DEPLOYMENT GUIDE 27

2 - IN-PATH DEPLOYMENTS

In-Path, Server-Side, One to One Deployment

An in-path, server-side, One to One deployment is appropriate for data center

LANs where you want to optimize applications on a single server or server

subnet. This deployment is simple to manage and LAN traffic is passed-

through.

The following figure illustrates the server-side of the network.

Figure 2-6. In-Path, Server-Side, One to One Deployment

Basic Steps

(Client-Side)

The client-side HP EFS WAN Accelerator is configured as an in-path device.

For detailed information, see the HP EFS WAN Accelerator Installation and

Configuration Guide.

Basic Steps

(Server-Side)

Perform the following steps for each of the server-side HP EFS WAN

Accelerators.

1. Configure the HP EFS WAN Accelerator as an in-path device. For detailed

information, see the HP EFS WAN Accelerator Installation and Configuration

Guide.

2. Connect to the Management Console. For detailed information, see the HP

EFS WAN Accelerator Management Console User Guide.

3. Navigate to the Setup: Advanced Networking - Failover Settings page in

the Management Console.

4. Enable failover support. For example:

 On HP EFS WAN Accelerator A, specify HP EFS WAN Accelerator A

as the master and specify the in-path IP address of HP EFS WAN

Accelerator B as the backup (other) IP address.

HP EFS WAN Accelerator