HP StorageWorks Enterprise File Services WAN Accelerator Deployment Guide (November 2005)

HP EFS WAN ACCELERATOR DEPLOYMENT GUIDE 53

6 - POLICY-BASED ROUTING

EPLOYMENTS

Configuring

PBR Using the

Management

Console

The following section describes the basic steps for configuring PBR using the

Management Console.

Basic Steps

(Client-Side)

Perform the following steps for each client-side HP EFS WAN Accelerator.

1. Configure the HP EFS WAN Accelerator as an in-path device. For detailed

information, see the HP EFS WAN Accelerator Installation and Configuration

Guide.

2. Connect to the Management Console. For detailed information, see the HP

EFS WAN Accelerator Installation and Configuration Guide.

3. Navigate to the Setup: Optimization Service - General Settings page in the

Management Console.

4. To enable PBR support, click Enable In-Path Support, Enable L4/PBR/

WCCP Support on Interface wan0_0 and Enable Optimizations on

inpath0_0, and inpath0_1.

Figure 6-2. Setup: Optimization Service - General Settings Page

5. Navigate to the Setup: Optimization Service - In-Path Rules page.