HP StorageWorks Enterprise File Services WAN Accelerator Deployment Guide (November 2005)

64 7 - WCCP DEPLOYMENTS
1. Create a service group on the router and set the router to redirect traffic to
the HP EFS WAN Accelerator using WCCP on the interfaces where traffic
goes.
2. Attach the WAN interface of the HP EFS WAN Accelerator to the network.
The WAN interface must be able to communicate with the switch or router
where WCCP is configured and where WCCP redirection will take place.
3. Configure the HP EFS WAN Accelerator to be an in-path device with
WCCP support on the client-side. For example, in-path oop enable.
4. Add fixed-target, in-path rules to reach the server-side HP EFS WAN
Accelerator.
5. Add the service group on the HP EFS WAN Accelerator.
6. Enable WCCP on the HP EFS WAN Accelerator.
WCCP CLI
Commands
This section summarizes the WCCP commands. For detailed information, see
the HP EFS WAN Accelerator Command-Line Interface Reference Manual.
 To enable client-side WCCP:
SH (config) # wccp enable

To disable client-side WCCP:
SH (config) # no wccp enable

To specify the multicast Time To Live (ttl) value for WCCP:
SH (config) # wccp mcast-ttl 10

To configure a service group:
SH (config) # wccp service-group <service ID> routers <IP address>
[flags ] [priority ] [ports ] [password ] [weight ] [encap_scheme ]