HP StorageWorks P9000 Performance Advisor Software v5.2 Install Guide (T1789-96317, May 2011)

2. Right-click the following Oracle database services, the HP StorageWorks P9000 Performance
Advisor Database and the HP StorageWorks P9000 Performance Advisor Database Listener,
and select Stop from the drop-down list.
3. Select Start > Run and type appwiz.cpl in the command line.
4. Remove Oracle from the list of programs.
5. Go to <Windows_Volume>:\Program Files and delete the folder for Oracle.
6. Reboot your management station, so that Oracle is completely removed.
Configuring a Loopback Adapter or static IP address
Configure a Loopback Adapter or a static IP address on your management station.
Loopback Adapter
A Loopback Adapter is required if you want to install P9000 Performance Advisor on:
• A DHCP computer
• A non-networked system and plan to connect the computer to a network after installation
NOTE:
The Loopback Adapter installed on the system must be made the primary network adapter.
To verify if a Loopback Adapter is already installed on your computer, run the ipconfig/all
command:
DRIVE_LETTER:\>ipconfig /all
If there is a Loopback Adapter installed, a section that lists the values for the Loopback Adapter is
displayed. For example:
Ethernet adapter Local Area Connec-
tion 2
Connection-specific DNS Suffix
Microsoft Loopback AdapterDescription
02-00-4C-4F-4F-50Physical Address
NoDHCP Enabled
169.254.25.129IP Address
255.255.0.0Subnet Mask
For more information on configuring Loopback Adapters, see Appendix A on page 155.
Static IP address
To assign a static IP address, do the following:
1. Right-click My Network Places and select Properties.
2. In the Network Connections window, right-click the network that you are using and select Prop-
erties from the pop-up list.
Understanding the P9000 Performance Advisor installation prerequisites30