HP StorageWorks P9000 Performance Advisor Software v5.2 Install Guide (T1789-96317, May 2011)

Logging into XP Remote Web Console through XP Command View AE
Complete the following steps to log onto the XP Remote Web Console:
1. Open an IE browser window and enter http://<ip_address>:23015/DeviceManager/
address in the browser address line to access the XP Command View AE Device Manager.
NOTE:
If you are using a secured connection, the port number is different and the URL format is as
follows:
http://<ip_address>:23016/DeviceManager/
2. In the Login window, enter the user name as system and the password as manager, and click
Login.
3. In the Command View XP AE Device Manager window, click the Resources tab in the CV AE
Device Manager Explorer navigation pane.
4. Click the Subsystems node and select the subsystem for which you want to create the command
device. (The individual subsystems are displayed in the Subsystems navigation pane, which is
on the right side of the Explorer navigation pane.)
5. Click Physical View to launch the Remote Web Console with administrator privileges.
Creating a command device for the XP24000/XP20000/XP12000/XP10000 Disk Array
After logging into the XP Remote Web Console (see Logging into XP Remote Web Console through
XP Command View AE on page 37), complete the following steps to create a command device:
1. In the XP RWC window, click GO > LUN Manager > LU Path and Security. A list of LDEVs appears.
2. Right-click the LDEV that you want to convert into a command device.
3. Select Enable\Disable from the drop-down list.
4. Click Apply to save the changes and enable the selected LDEV as a command device.
CAUTION:
The volume designated as the command device is used only by the disk array and is blocked from
the user. Because the volume you select as a command device becomes unavailable to the host, HP
recommends that you use a volume that does not contain data or mounted files. The command device
can be any device that is accessible to the host.
Creating a command device for the XP1024/XP128 Disk Array
After logging into the XP Remote Web Console (see Logging into XP Remote Web Console through
XP Command View AE on page 37), complete the following steps to create a command device:
1. Click Physical View to open the LDEV Information window.
2. Click VIEW for the desired frame on the ARRAY GROUPS view.
3. Select the desired parity group in the Frame Information window, and then select the desired
array group on the next Frame Information window.
4. From the LDEV list, select the LDEV that you want to convert into a command device. The details
of the selected LDEV are displayed in the LDEV Information display area.
HP StorageWorks P9000 Performance Advisor Software Installation Guide 37