HP StorageWorks P9000 Performance Advisor Software v5.2 Install Guide (T1789-96317, May 2011)
3 Installing P9000 Performance Advisor
This chapter describes the process of installing P9000 Performance Advisor on a management station.
The installation process is described in the following topics:
• “Beginning the P9000 Performance Advisor installation” on page 43
• “Launching the P9000 Performance Advisor checklist” on page 46
• “Complying with the End User License Agreement” on page 46
• “Retaining or selecting a different database location” on page 47
• “Enabling IPv6 and configuring HTTP port for the management station” on page 47
• “Implementing the authentication method” on page 48
• “Selecting complete or custom installation method” on page 56
• “Completing the P9000 Performance Advisor installation and next steps” on page 60
If an earlier version of P9000 Performance Advisor exists on your management station and you want
to upgrade to the latest version, see Table 8 on page 100.
Beginning the P9000 Performance Advisor installation
NOTE:
This section is also applicable for the upgrade process.
To begin the P9000 Performance Advisor installation:
1. Log on to your management station as an administrator (administrator:administrator).
2. Insert the P9000 Performance Advisor Installation disk 1 into the DVD drive. If the installation
wizard does not start automatically, run the PA_Server.exe file from the P9000 Performance
Advisor Installation disk 1.
Right-click the PA_Server.exe file and select Run as Administrator from the drop-down list, if
you are installing or upgrading P9000 Performance Advisor on a Windows management station,
where UAC is enabled.
HP StorageWorks P9000 Performance Advisor Software Installation Guide 43