HP StorageWorks P9000 Performance Advisor Software v5.2 Install Guide (T1789-96317, May 2011)

3. Enter the HTTP Port number that the host agent should use to communicate with P9000 Performance
Advisor on the management station.
The port number that you enter must be the same as that provided when installing P9000
Performance Advisor on the management station. Port 80 is the default port number, which you
can retain or provide a different port number.
4. Click Next to proceed.
The Connectivity Test window appears. For more information on the next set of steps, “Testing
validity, connectivity, and GUID configuration” on page 75.
Testing validity, connectivity, and GUID configuration
Test whether the DNS or IP address, and HTTP port of the management station that you provided is
valid, and whether you are able to assign a command device to the host agent. Also, test whether
the Windows GUID (\\?\Volume{GUID}) is created and assigned to command devices on the Windows
host.
NOTE:
These verification tests only help you to verify if the details provided are accurate. Even if the tests are
not successful, the host agent installation does not stop. You can rectify the errors and proceed with
the installation, or complete the installation and then resolve the validity and connectivity issues. For
more information on resolving errors later, see Resolving validity, connectivity, and GUID configuration
errors after installation on page 76.
To test validity, connectivity, and the GUID configuration:
HP StorageWorks P9000 Performance Advisor Software Installation Guide 75