HP StorageWorks P9000 Performance Advisor Software v5.3 User and Troubleshooting Guide (T1789-96322, August 2011)

3. Click Add Alarms. The Add Alarms button is enabled only when you select a component in the
component selection tree.
The records are automatically displayed in the Alarms table under the Alarms Configuration tab.
Initially, when alarms are not yet configured on the selected components, the following
informational message No alarms are configured appears above the Alarms table under
the Alarms Configuration tab.
The following are examples on selecting components and adding records for them in the Alarms table:
Adding record for a P9000 disk array:
• The P9000 disk array selected is 53036 in the component selection tree (see following image).
• The corresponding metric selected in the Choose Metric(s) box is SM CHIP Bus/FBus Hi Util.
When you click Add Alarms, the record pertaining to 53036 and the SM CHIP Bus/FBus Hi Util
metric is added to the Alarms table under the Alarm Configuration tab. The Resource column displays
All, which implies that the alarm is configured within the scope of the selected metric on all the
components in 53036.
Adding records for components in a component type:
• The component type selected is Processors (4) in the component selection tree [MP Blades > MPB-
1MA > Processors (4)]
• The corresponding metric selected in the Choose Metric(s) box is MP Blade Processor Util
When you click Add Alarms, records for all the four processors in the Processors component type are
added to the Alarms table under the Alarm Configuration tab. The Resource column displays the
names of the four processors. The Metric column displays the selected metric, which is MP Blade
Processor Util %.
HP StorageWorks P9000 Performance Advisor Software User Guide 145