HP StorageWorks P9000 Performance Advisor Software v5.3 User and Troubleshooting Guide (T1789-96322, August 2011)

Filtering LDEV records
Records in the LDEV table can be filtered in the following ways:
• Filter records based on user specified criteria
• Filter records based on existing selection
• Filter records for values greater or lesser than the specified value
Filter records based on user specified criteria
This type of filter is applicable when you want to view the LDEV data based on the filter criteria that
you specify. If the existing list of LDEV records in the LDEV table do not match the specified filter
criteria, the data is collected from the XP or the P9000 disk array and displayed in the LDEV table.
Following is an example on filtering records in the LDEV ID list:
1. Click the LDEV ID list.
2. In the LDEV ID filter that appears, provide the LDEV ID. You can also enter multiple LDEV IDs in
the following format: CU:LDEV1,CU:LDEV2,CU:LDEV3
3. Click OK.
The LDEV table displays only those records that match the specified LDEV IDs.
Filter records based on existing selection
This type of filter is applicable when you want to view the LDEV data based on your selection from
an existing filter criteria. Following is an example on filtering records in the RAID Group list:
1. Click the RG list.
2. In the RAID Group filter that appears, select the check box for those RAID groups, for which you
want to view the corresponding LDEV data.
3. Click OK.
Viewing XP and P9000 disk array components250