HP StorageWorks P9000 Performance Advisor Software v5.3 User and Troubleshooting Guide (T1789-96322, August 2011)

DescriptionScreen elements
The ID of the pool (pool number)THP Pool ID
The status of the ThP Pool
• 0: Undefined/Creating/Deleting – Specified pool
does not exist completely.
• 1: Normal
• 2: Pool capacity beyond threshold
• 3: Pool capacity reached 100% of the pool
• 4: Failure, cannot show further information for the
pool
THP Pool Status
A user configurable pool threshold (varying between
5% - 95% in increments of 5%). The default value is
70%. This is the high for the pool.
POOL Threshold 1
The threshold level that indicates the WARNING level
for the pool. This value is always 80% and cannot be
changed.
POOL Threshold 2
The total capacity of all the ThP volumes in the pool.THP Pool capacity
The available capacity for the ThP pool.THP Pool unused capacity
The CU:LDEV identifier for the virtual volume (V-VOL).VVOL ID
The threshold set for the V-VOL in ThP pool.VVOL Threshold (%)
The capacity of the virtual volume (in MB).VVOL Capacity (MB)
The physical LDEV that is part of the pool.REAL LDEV
The RAID group of the real LDEV.RG(s)
The ACP pair that manages the real LDEV.ACP Pair
Viewing port information
Click a CHP Port ID value in the LDEV table to view the Port Information window.
The DKC serial number is displayed. In addition, the port type, such as Fibre, Ficon, Escon, or FCoE
(applicable only for P9000 disk arrays) is also displayed for the respective CHIP port ID.
Click the IO/s Charts or MB/s Charts to view the respective charts.
Viewing XP and P9000 disk array components254