HP StorageWorks P9000 Performance Advisor Software v5.3 User and Troubleshooting Guide (T1789-96322, August 2011)
• “Deleting configuration data collection schedules” on page 67
• “Performance data” on page 68
• “Providing user-friendly names for XP and P9000 disk arrays” on page 96
• “Registering the XP or P9000 disk array SVP IP address in P9000 Performance Advisor” on page 96
• “Filtering event records” on page 167
• “Configuring email and SNMP settings” on page 92
• “Starting real-time performance data collection” on page 85
• “Viewing performance summary” on page 206
• “Plotting charts” on page 264
Configuration collection schedules
The following table describes the configuration collection schedules.
ExamplesDescriptionCollection
Schedule
If you create an hourly
schedule at 12:30 PM and
set the schedule frequency as
1 hour, P9000 Performance
Advisor executes the
schedule only at 1:00 PM
and collects data for the next
one hour. A new instance of
the schedule executes at
2:00 PM again. This process
repeats for every 1 hour.
If the collection schedule is selected as Hourly, the Hourly
Schedule list appears. Select the schedule frequency as 1 hour,
6 hours, or 12 hours.
The Start Time list is not enabled for the Hourly collection
schedule.
Hourly
If the collection schedule is selected as Daily, provide the
schedule start time. Every time the schedule is executed, P9000
Performance Advisor collects the configuration data for the last
24 hours only.
Daily
If the collection schedule is selected as Weekly, the Day of the
Week list appears. Select the day and provide the schedule start
time. Every time the schedule is executed, P9000 Performance
Advisor collects the configuration data for the last one week
only.
Weekly
Collecting configuration and performance data66