HP XP P9000 Performance Advisor Software v5.5 Command-line User Interface Reference Guide (T1789-96338, February 2013)

3This means P(S)vol Journal is Normal Full.JSTAT_PJNF
4This means P(S)vol Journal is Suspend Full.JSTAT_PJSF
5This means P(S)vol Journal is Suspend Error including link failure.JSTAT_PJSE
Secondary Journal:
Constant valueStatus valueString
17This means S(S)vol Journal is Normal NormalJSTAT_SJNN
18This means S(S)vol Journal is Suspend Normal.JSTAT_SJNF
19This means S(S)vol Journal is Normal Full.JSTAT_SJSN
20This means S(S)vol Journal is Suspend Full.JSTAT_SJSF
21This means S(S)vol Journal is Suspend Error including Link failure.JSTAT_SJSE
Displays the actual number of paths.AP
Displays the usage rate of the journal pool in percentage format.U(%)
Displays the sequence number for the journal group ID, called the Q-marker.Q-Marker
Displays the number of remaining Q-Markers within each journal volume.Q-CNT
Displays the number of volumes configured for the journal group.Num
Displays the ID of the volume configured for the journal group.LDEV#
Displays the average read response time of the volume configured for the journal group.Avg Read
Displays the maximum read response time of the volume configured for the journal group.Max Read
N/AAvg Write
N/AMax Write
NOTE: Average and Maximum write metrics are not supported for the continuous access journal
pool LDEVs.
Switches
Required: Specify the array serial number.—dkc <serial #>
Specify the journal ID.–jid <journal pool id>
The journal LDEV's read and write response time.–resp
Specify the start time in the format mm.dd.yyyy hh:mm:ss.–st <mm.dd.yyyy
hh:mm:ss>
Specify the end time in the format mm.dd.yyyy hh:mm:ss.–et <mm.dd.yyyy
hh:mm:ss>
Specify the address of a management station in the format <http://
path.to.managementstation:<port>> or <https://
path.to.managementstation>.
–ms <URL>
Specify a user name and password pair in the format user name:password.–auth <user:passwd>
Can be used in place of –auth.
NOTE: The password file must be created using the encrypt command only.
–pf <password file>
Specify the delimiter for delimited display.–d<delim>
Display column headers with delimited data.–L
42 CLUI commands