HP XP7 PA Software Installation Guide

TCP 0.0.0.0:80 0.0.0.0:0 LISTENING 804
The last column of the output from the above command is the process identifier (PID), denoted by
<process_ID>. In the example output, the PID is 804.
To forcibly terminate the process which is using the port, execute the following command:
TASKKILL /F /PID <Port # PID>
Following is an example for terminating the process that is using port 80:
TASKKILL /F /PID <Port 80 PID>
Where, <Port 80 PID> is replaced by the process identifier of the task currently using port 80.
Increasing the virtual memory on your management station
Increase the virtual memory for the <Installation_Drive>, where you intend to install HP
XP7 Performance Advisor to the maximum configurable paging file size that your system supports.
To manually allocate the virtual memory (custom page file size) to the <Installation_Drive>:
NOTE: The steps provided are applicable for the Windows XP operating platform. For increasing
the paging file size on another Windows operating platform, see the documentation provided for
that Windows operating platform.
1. Right-click My Computer and select Properties from the pop-up list.
2. In the System Properties window, click the Advanced tab.
3. Under Performance, click Settings.
4. In the Performance Options window, click the Advanced tab.
5. Click Change under Virtual Memory.
6. In the Virtual Memory window, click Custom Size (if not already selected).
7. Provide the maximum configurable custom page file size in the Initial Size (MB) box. The value
that you provide must be equal to the Maximum Size (MB).
By manually adding a custom page file size to the <Installation_Drive>, it also registers
a Page File Size (MB), which is displayed against the corresponding Drive [Volume Label]
under Virtual Memory.
8. Click OK on the Virtual Memory, Performance Options, and System Properties windows to
save the changes, and close the windows.
Configuring the web browser proxy server settings
IMPORTANT: Perform this procedure after you complete installing HP XP7 Performance Advisor.
Configure your IE browser to not use a proxy server for the IP address or fully qualified domain
names. To configure the IE browser proxy server settings:
1. In a IE browser window, click Tools+Internet Options+Connections+LAN Settings.
2. In the Local Area Network (LAN) Settings window, select the Use a proxy server for your LAN
(These settings will not apply to dial-up or VPN connections) check box.
3. Click Advanced.
4. In the Exceptions text box, place your cursor at the end of the domain list.
5. Enter a semicolon and your IP address, and the fully-qualified domain name of the management
station.
6. Click OK to save changes.
34 Understanding the HP XP7 Performance Advisor installation prerequisites