P9000Watch and P9000Sketch Reference guide for HP StorageWorks P9000 Performance Advisor v5.3 (T1789-96325, August 2011)

Table 4 lists the Selection options available in the P9000Watch interface and their functions.
Table 4 Selection options
FunctionOptionCommand
To select all items in a given menu.Select Alla
To clear all the selected items in a given
menu.
Select Noner
Table 5 lists the Miscellaneous options available in the P9000Watch interface and their functions.
Table 5 Miscellaneous options
FunctionOptionCommand
To change the settings of P9000Watch.Settingss
To view the Nickname menu.Nickname Menux
Executing commands in CLI mode
NOTE:
If none of the below mentioned commands are provided, P9000Watch is executed in the Interactive
mode.
Syntax conventions
Table 8 lists the symbols that are used to depict command syntax. This table supplements the conventions
described in Document conventions and symbols.
Table 6 Syntax conventions
MeaningSymbol
Indicates optional items.
For example, if this is given in the syntax [-f <filename>], then it implies that it is an optional
parameter and you can execute the command without this parameter.
[ ]
Indicates a value that you define.
For example, –s <array-serial number> will have the value –s 10090
< >
Separates mutually exclusive choices. Type one of the choices.
For example, –l <all|ldev-list> implies that you can either select all the LDEVs or you can
specifically list the LDEVs as –l 00:01,00:02
|
You can execute the following commands to use P9000Watch in the CLI mode:
./xpwatch –c –s <array-serial number> –hg <host-groups> [–f <filename>] [–a <frequency for archiving
data>] –hrs <number of hours for execution> —min <number of minutes for execution>
To view the P9000Watch in CLI mode.—c
P9000Watch and P9000Sketch Reference Guide 21