HP Reference Information Storage System Version 1.6 Administration Guide revision 2 (T3559-90809, September 2007)

3. If the database server was reinstalled, run one of the following commands to restore the

/db2/VolBack par tition from either the version stored on the kickstar t server or tape backups.

NOTE:

This will delete the content of the VolBack directory.

•

/opt/bin/backup/db2BackupUtility -restore_from_kickstart

•

/opt/bin/backup/db2BackupUtility -restore_from_tape

4. To restore the da tabase, make sure the database is up by issuing the command:

su – db2udb –c db2start

5. To restore DB2, run the following comma nd. It will ask for a timestamp of a backup to restore.

Normally, the last two b ackups of the database are kept.

/opt/bin/backup/db2BackupUtility -restore_db2

6. After the installation is ﬁnished, run /opt/bin/start on the PCC serv er to start the RISS sy stem

and validate that it operates correctly.

Restoring the master conﬁguration ﬁles

Copies of the master conﬁguration ﬁles are kept in the /usr/local/MasterConfigFiles

directory on the PCC server. Whenever one of the ﬁles is changed on the kickstart server and

the conver ter is run, the master conﬁgu ration ﬁle is c opied to the PCC server, and renamed to

YYYY-MM-DD-hh.mm.ss_FileName. It is also backed up to tape, if application backup is enabled.

To restore this directory from the tape backup, run the following command on the PCC ser ver:

/usr/local/tsmBackup/rotateMasterConfigBackup –restore

Data management