Installation and Reference Guide for HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays 3.00.00 (AA-RW8SF-TE, March 2008)

Upgrading HP MPI

OEVADSMonclusterconﬁgurations

To upgrade HP MP

IO EVA DSM from a previous version on each member of a cluster conﬁguration,

complete the steps below:

NOTE:

In a cluster conﬁguration, HP MPIO EVA DSM must be upgraded on one node at a tim e for all nodes in

the cluster.

1. Complete the pre-installation checklist ( Table 2) and the pre-installation procedure.

2. Using Cluster Administrator:

a. Move all cluster resources owned by the current node to another node in the cluster.

b. Pause the current cluster node.

c. Disable failback for all groups containing resources managed by the current node.

3. Upgrade HP MPIO EVA DSM on the current node by following steps 2–6 from the procedure

Upgrading HP MPIO EVA DSM on stand-alone systems.

4. Using Cluster Administrator , resume the current cluster node.

NOTE:

Repeat steps 2–4 for all nodes in the cluster.

5. Using Cluster Administrator:

a. Restore failback for all groups containing resources as needed.

b. Redistribute cluster resources as desired.

Migrating from Windows Server 2003 to Windows Server

2008 with HP MPIO EVA DSM

To migrate

from Windows Server 2003 to Windows Server 2008 with HP MPIO EVA DSM, complete

the steps below:

1. Back up all user data.

2. Install o

r upgrade to HP M PIO EVA DSM 3.00.00, see Chapter 1.

3. Upgrade to Windows Server 2008.

4. Double-click the batch ﬁle (depending on your operating system):

•ForWindowsServer2008x86:

<Target

_Dir>\x86\Win2k8Upgrade.bat

• For Windows Server 2008 IA64:

<Target_Dir>\ia64\Win2k8Upgrade.bat

•ForWind

ows Server 2008 x64:

<Target_Dir>\amd64\Win2k8Upgrade.bat

NOTE:

To upgrade from cluster conﬁguration in Windows Server 2003 to Windows Server 2008,

please refer to h

ttp://support.microsoft.com/kb/935197

Installing the HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays