Installation and Reference Guide for HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays 3.00.00 (AA-RW8SF-TE, March 2008)

•UpgradingHPMPIOEVADSM
•RemovingHPMPIOEVADSM
• Creating response files for silent mode operations
Syntax:
<install_dir>:\MPInstall\setup.exe /s /f1"C:\setup.iss" /f2"C:\MPSInstallLog.txt”
The <install_dir> refers to the drive which contains the installation media.
The setup.iss is the response file from which information is taken for silent installation.
The MPSInstallLog.txt file records information about the silent installation.
The ResponseResult section of the MPSInstallLog.txt log file displays the result code, indicating
whether or not the silent installation succee d e d. An integer value is assigned to the ResultCode
keyname in the ResponseResult section.
Following are the list of common return values along with their descriptions in the ResultCode key:
Result Code
Description
0Success
–1
General error
–3
Required data
not found in the setup.iss fi le
–4
Not enough memory available
–5
File does not exist
–6
Cannot write
to the response file
–7
Unable to write to the log file
–8
Invalid path to the InstallShield Silent response (.iss) file
–51
Cannot creat
ethespecified folder
–52
Cannot access the specified file or folder
NOTE:
The C: in /f1C: and /f2C: refers to a local drive on the system or a network driv e which is used
to obtain the response file and write the MPSInstallLog.txt (provided there is write permission
in the d irec
tory).
• For 32 bit systems: <Default_Target_Dir> = C:\Program Files\Hewlett-
Packard\HP MPIO DSM\EGL DSM
• For 64 bit sy
stems: <Default_Target_Dir> = C:\Program Files (x86)\Hewlett-
Packard\HP MPIO DSM\EGL DSM
<User_Target_Dir>= a directory on the system on which the new installation is to be done or
the directory of an existing installation.
You must en
close the paths to the response file and the log file, which records the information about
the silent installation, in quotes ("").
Installing HP MPIO EVA DSM
To perform a silent installation of HP MPIO EVA DSM, complete the steps below:
1. Make a copy of the new.iss file in the installation kit.
2. Rename this copy of the file as setup.iss
3. Choose one of the following options:
16
Installing the HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays