Installation and Reference Guide for HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays 3.00.00 (AA-RW8SF-TE, March 2008)

7 COMPAQ
HSV111_(C)COM-
PAQ
600508B4000149B50002800000410000 8
RR
Disk7 3.0.3.7
N
8 COMPAQ
HSV111_(C)COM-
PAQ
600508B4000149B50002800000470000 8
SQR
Disk8 3.0.3.8
N
9 COMPAQ
HSV111_(C)COM-
PAQ
600508B4000149B500028000004D0000 8
SQR
Disk9 3.0.3.9
N
hpdsm devices all
Syntax: hpdsm devices all
The hpdsm dev
ices all command displays the information of the device, followed by their path
information as shown in the following example. If there are no devices present, the following message
is displayed: No devices found.
NOTE:
See hpdsm se
t device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices all
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
1
HP HSV110 6005008B400101F6000170000 2
SQST
Disk1 4.0.2.3
N
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1
P898DXAAQQO101U-2 Active
7
00010002 3.0.2.3
2 P898DXAAQQO101U-2 Active 6 00010002 4.0.2.3
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
2 HP HSV110 6005008B400101F600018000 2
SQST
Disk2 3.0.2.4
N
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1 P898DXAAQQO101U-2 Active
7
00010002 3.0.2.4
2 P898DXAAQQO101U-2 Active6 6 00010002 4.0.2.4
hpdsm paths device
Syntax: hpdsm paths device=x
The hpdsm paths device command displays information about the paths available for device x,as
shown in the following example.
28
Managing storage arrays using the HP MPIO EVA DSM with the CLI utility