Installation and Reference Guide for HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays 3.00.00 (AA-RW8SF-TE, March 2008)

hpdsm paths device=x set device=1 path=1
Device Name
: COMPAQ HSV111_(C)COMPAQ
Device Serial No. : 600508B4000149B500028000001D0000
Controller Port No.
: P4889B59IM501F
Change Load Balance policy (y/n)? y
Preferred Path
changed. Verify by issuing "hpdsm paths device=<number>" command.
hpdsm cleanup device
Syntax: hpdsm cleanup device=x
Syntax: hpdsm cleanup device=all
The hpdsm cleanup device command allows you to clean up the failed path information for a
specified device x or for all the devices, depending on the input parameters specified, as shown
in the example below.
Example:
hpdsm cleanup
device=1
Device Name
: COMPAQ HSV111_(C)COMPAQ
Device Serial No. : 600508B4000149B500028000001D0000
Cleanup the fa
iled path information for this LUN (y/n)? y
Cleanup Succeeded. Verify by issuing "hpdsm devices" command.
Example:
hpdsm cleanup device=all
Successful for all the devices. Verify by issuing "hpdsm devices" command.
hpdsm notify
Syntax: hpdsm notify event=notification_event_number time=number_of_minutes
The hpdsm notify command defines user notification of events. The time attribute defines the number
of minutes t
hat elapses from the time the event occurs until the user is notified. The maximum value
that can be entered is 35000 minutes.
NOTE:
Syntax: hpdsm notify event=notification_event_number
The above command will make the notification to wait indefinitely until the user terminates the wait
(eg: with Ctrl-C).
Table 3 defines the selections for the notification command string.
HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays 3.00.00
31