HP XP P9000 Remote Web Console User Guide

Setting fields
DescriptionItem
Specify whether SIMs are reported to syslogs in the primary server.Primary Server
• Enable: SIMs are reported to syslogs in the primary server.
• Disable: SIMs are not reported to syslogs in the primary server.
Specify an IP address of the primary syslog server. You can specify an IPv4 address or
an IPv6 address.
Primary Server - IP Address
• To specify an IPv4 address, select IPv4 and enter 4 numbers (0-255).
For example:
XXX.XXX.XXX.XXX (X indicates a digit)
• To specify an IPv6 address, select IPv6 and enter 8 hexadecimal numbers (0-FFFF).
For example:
YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY (Y indicates a hexadecimal digit)
Enter a port number of the primary syslog server.Primary Server - Port
Number
The default port number is displayed. You can also specify any port number.
Specify whether SIMs are reported to syslogs in the secondary server.Secondary Server
• Enable: SIMs are reported to syslogs in the secondary server.
• Disable: SIMs are not reported to syslogs in the secondary server.
Specify an IP address of the secondary syslog server. You can specify an IPv4 address
or an IPv6 address.
Secondary Server - IP
Address
• To specify an IPv4 address, select IPv4 and enter 4 numbers (0-255).
For example:
XXX.XXX.XXX.XXX (X indicates a digit)
• To specify an IPv6 address, select IPv6 and enter 8 hexadecimal numbers (0-FFFF).
For example:
YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY (Y indicates a hexadecimal digit)
Enter a port number of the secondary syslog server.Secondary Server - Port
Number
The default port number is displayed. You can also specify any port number.
Specify any name to identify the storage system that notifies the syslog server of SIMs.Location Identification Name
Up to 32 letters and numbers of ASCII code characters and the following symbols can
be specified:
! " # $ % and ' ( ) = - ~ ^ | \ { } [ ] @ ` : ; * + _ ? / < > .
You cannot specify commas (,) and spaces.
If this is checked, test SIMs are reported to syslogs as you configure the servers.Send a test message
200 Remote Web Console GUI reference (main window)