HP XP P9000 Remote Web Console User Guide
To restore the configuration files:
1. Start a Web browser, and enter the following URL to open the tool panel:
http://IP-address-or-host-name-of-SVP/cgi-bin/utility/toolpanel.cgi
2. Click Control Panel to open the Control Panel.
3. Enter the user ID and password, and click Login.
4. Click the Restore tab to open the Restore dialog box.
5. Click the files, and click Browse to specify the directory of the file. You can restore only the
files for which you have permission.
6. Click Next.
7. Click the configuration files to restore.
8. Click Submit.
9. If the Password check dialog box opens, enter appropriate information in the User ID, Password,
and Re-enter Password fields of the storage administrator on the backup user list, and click
Submit on the Password check dialog box.
The Restore File dialog box opens.
10. Confirm the restoring process has been completed successfully.
11. Click Close to close the dialog box.
Setting and configuring syslog notification for SIMs
You can be notified in syslog format when storage system failures occur. Failures notified in
syslog format are the same as failures reported by SIMs displayed in the Alerts window or failures
reported by SNMP traps.
Prerequisites
• You must have the storage administrator (initial configuration) role to perform this task. See
Table 8 (page 43).
• You must have a server that supports syslogs.
• If a firewall is used, a port must be opened to transfer syslogs.
To configure settings for syslog notification:
1. Click Settings→Environmental Setting→Edit SIM Syslog Server Settings.
2. Select Enable, and enter the IP address and port number to transfer syslogs to a primary server.
3. Select Enable, and enter the IP address and port number to transfer syslogs to a secondary
server.
4. Specify any name in the Location Identification Name field to identify the storage system.
5. Click Finish
6. Specify a task name, and click Apply.
Sending a test syslog
After configuring the syslog notification, send a test syslog to verify your settings.
Prerequisites
• You must have the Storage Administrator (Initial Configuration) role to perform this task. See
Table 8 (page 43).
• Complete the configuration of the syslog server.
62 Configuring the Remote Web Console environment