Installing and configuring HP SIM 6.x on HP Integrity VM

9
Configure the VSE Management Software by executing the following command:
/opt/vse/bin/vseinitconfig
–
a
The
vseinitconfig
command logs status, errors, and exceptions to the file
/var/opt/
vse/logs/vseinitconfig.log
.
Configuring
HP
SIM
for
VSE
1.
Ensure that the
SSH
is installed and configured for HP SIM on each of your managed systems.
T
o
c
onfigure
SSH
for HP SIM, sele
c
t the systems to
c
onfigure, and
then
from
the HP SIM menu
,
select
Configu
r
e
>
C
onf
i
gu
r
e
or Repair Agents
.
2.
From the HP SIM menu, s
ele
c
t the managed systems
,
and
then select
Configu
r
e
>
C
onf
i
gu
r
e
VSE
A
g
e
n
ts
>
I
n
stall
VSE
A
g
e
n
ts...
. Click
Run
Now
to start the installation. Review the output for error
messages before
c
ontinuing.
3.
R
u
n the
HP SIM discovery process again on the
managed systems where agent software has been
installed. This
process
ca
u
se
s
HP SIM to
u
pdate its information abo
u
t these systems. Select the
affected systems
,
from the HP SIM menu bar
select,
Options
>
Disco
v
er
y
...
, and
then click
Run
No
w
.
The Virt
u
a
l Host and the virt
u
a
l machine can be managed with HP SIM, as shown in
Figure
3
.
Note:
VSE is not requir
ed for the Virtual Machine Host and Virt
u
a
l Machines to be
associated.
Once discovered and identified, the virtual m
a
chine associates
itself to the host.