HP Systems Insight Manager 6.3 Installation and Configuration Guide for Microsoft Windows

7. When the Select Installation Type window appears, select Typical to install the included
components with minimal user interaction listed under the Available Components for Install or
select Custom to select the individual components under the Available Components for Install
and configure them during installation.
NOTE: If a component is listed as not available for installation on the CMS, then the HP
Systems Insight Manager install shell has determined one of the following:
• The installation prerequisites for the component have not been met.
• The same or a newer version of the component is currently installed.
If the component that is present on the CMS is an older version than what is bundled with the
HP Systems Insight Manager install shell and it supports an in-place upgrade, it appears in
the component list.
Typical upgrade
Typical upgrade, upgrades all the components which are marked included under the Available
Components for Install.
Procedure 12 Typical upgrade
1. Click Next, the Service Account Credentials window appears. You must use credentials for an
administrative account.
2. Enter the password for this account. Click Next, the Summary window appears with the
components that are to be installed.
3. Click Install to initiate the installation process. This process installs all the products listed in
the Selected Components table. The Status window appears. As each component is being
installed, it states "In Progress" beside the component's name. After the component has installed,
it states Installed Successfully.
4. After all of the components are installed, click Next.
5. The Registration window appears. Register HP Systems Insight Manager or click Register Later.
NOTE: If you do not have Internet access, click Register Later or navigate to http://
h20293.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=HPSIM-LIC
to register.
When the Install Complete window appears, you are given the option to reboot. The following
message appears: For this upgrade install, HP recommends that you
configure the HP System Management Homepage to use operating system
authentication for VCA.full.name; access to Version Control
Repository Manager, and then re-configure the servers running
VCA.full.name; to use the new account. If these actions are not
taken, pre-7.20 Version Control Agents will access your upgraded
Version Control Repository through legacy HTTP Server account access.
For more information, see the Version Control Installation Guide at http://
h18013.www1.hp.com/products/servers/management/agents/documentation.html
6. Click Finish to allow the system to reboot. This completes the typical upgrade process. For
more information, see “Next steps” (page 51).
NOTE: For more information regarding where the HP System Management Homepage
default settings are stored during a Typical installation and how to change them, see the HP
System Management Homepage Installation Guide at http://h18013.www1.hp.com/products/
servers/management/agents/documentation.html.
Typical upgrade 45