HP Systems Insight Manager 5.2 Installation and Configuration Guide for HP-UX

enter Simple or Fully Qualified Domain Names (FQDN) host names. However, you cannot enter a range

of host names. This field applies to both range-pinging and event-based automatic discovery.

Important: When discovering clusters, the ping inclusion range must include the IP addresses of the

cluster and the cluster members.

5. Select Enable discovery filters.

6. In the section, Discover the following system types, select the type of systems to be discovered.

Important: When discovering clusters, you must include the server system type, so that the cluster members

are not filtered out.

Note: This option is available only when you select Enable discovery filters.

7. In the Limit discovery to systems that meet the following criteria section, select from the following:

• Any system that matches the above filter

• All manageable systems (WBEM, SNMP, DMI, WMI, or HTTP support)

• Manageable systems with HP agents only

Note: The option, Limit discovery to systems which meet the following criteria is available only

when you select Enable discovery filters.

8. To save settings, click OK, or to close the General Settings for All Discoveries section without saving

changes, click Cancel.

If you click OK when discovery filters are enabled but have not selected any system types, the following

error message appears:

You must make at least one system type selection when enabling filters.

9. Select System Automatic Discovery. Click one of the following options to schedule it for ongoing

operations or to make other changes: Edit, Enable or Run Now. If you would like to create other

discovery tasks, click New.

Configuring and executing manual discovery

1. Select Options→Discovery, and then click the Manual tab. The System Information section appears.

2. Enter the system name or IP address. Simple or Fully Qualified Domain Name (FQDN) host names can

be entered. However, ranges of host names are not allowed.

3. Click Add System to add the system to the database. If you have not entered the

SNMP

Web-Based

Enterprise Management

(WBEM) credentials for this system previously, click More Settings. Enter the

credentials, then click Add System, or click More Settingsand enter the following information:

44 Configuring HP SIM using the Options menu