Setting up HP SIM 5.x on an HP-UX Serviceguard Cluster (448492-002, February 2008)

ManualsBrandsHP ManualsSoftwareHP Systems Insight Manager 5.x Linux Software

HEARTBEAT_IP 10.0.0.32

# Cluster Timing Parameters (microseconds).

# The NODE_TIMEOUT parameter defaults to 2000000 (2 seconds).

# This default setting yields the fastest cluster reformations.

# However, the use

of the default value increases the potential

# for spurious reformations due to momentary system hangs or

# network load spikes.

# For a significant portion of installations, a setting of

# 5000000 to 8000000 (5 to 8 seconds) is more appropriate.

# The max

imum value recommended for NODE_TIMEOUT is 30000000

# (30 seconds).

HEARTBEAT_INTERVAL 1000000

NODE_TIMEOUT 2000000

# Configuration/Reconfiguration Timing Parameters (microseconds).

AUTO_START_TIMEOUT 600000000

NETWORK_POLLING_

INTERVAL 2000000

# Package Configuration Parameters.

# Enter the maximum number of packages which will be configured in the

cluster.

# You can not add packages beyond this limit.

# This parameter is required.

MAX_CONFIGURED_PACKAGES 20

EOF

eplication on node SG2hpsimlnx

scp

p $SGCONF/cluster.conf $SGCONF/cmclnodelist SG2hpsimlnx:$SGCONF

Applying the configuration

cmapplyconf

C cluster.conf

Begin cluster verification...

Checking cluster file: cluster.conf

Note : a NODE_TIMEOUT value

of 2000000 was found in line 54. This value

is recommended if the top priority is to reform the cluster as fast

as possible in case of failure. If the top priority is to minimize

reformations, consider using a higher setting. For more information see

the c

luster configuration ASCII file or the Managing Serviceguard manual.

Checking nodes ... Done

Checking existing configuration ... Done

Gathering storage information

Gathering network information

Beginning network probing (this may take a while)

Completed ne

twork probing

Checking for inconsistencies

Maximum configured packages parameter is 20.

Configuring 0 package(s).

20 package(s) can be added to this cluster.

200 access policies can be added to this cluster.

Creating the cluster configuration for cluster s

ghpsimlnx

Adding node SG1hpsimlnx to cluster sghpsimlnx

Adding node SG2hpsimlnx to cluster sghpsimlnx

Completed the cluster creation

Start the SGLX cluster

cmruncl

cmruncl: Validating network configuration...

cmruncl: Network validation complete

Wait

ing for cluster to form ..... done

Cluster successfully formed.