HP Systems Insight Manager 7.3 Installation and Configuration Guide for Linux

Configuring SMI-S providers
Occasionally, it might be necessary to modify an SMI-S provider's port number or password. Use
the provider documentation to perform these modifications.
For example, if two CIMOMs exist on the same host, you must configure them to use different ports
to communicate with the CMS.
Configuring HP SIM to discover storage systems
After verifying that each storage system's SMI-S provider is installed and configured, configure HP
SIM to discover the storage systems by performing the following steps:
1. Enter the user name and password for each provider's SMI CIMOM in the Default WBEM
settings section on the Setting Global Protocols page.
2. Add each SMI CIMOM IP address to the System Automatic Discovery task or to the Creating
a New Discovery task. For more information, see the http://www.hp.com/go/
insightmanagement/sim/docs.
HP SIM discovers the storage systems after the next automatic discovery task. To discover your
storage systems immediately, run the discovery task as described in the Running a Discovery Task
section of the http://www.hp.com/go/insightmanagement/sim/docs.
RHEL 6.0 installation instructions
For successfully installing RHEL 6.0, the versions/packages mentioned in this section must be
followed as pre-requisites:
NOTE: These libraries are necessary for the optimal deployment of the software and firmware
upgrade tasks on the system, where HP Version Control Agent is not used on the target systems.
• lm-sensors-libs-3.1.1-10.el6.<arch>.rpm
• net-snmp-libs-5.5-27.el6.<arch>.rpm
• net-snmp-5.5.27.el6.<arch>.rpm
• kernel-headers-2.6.32-71.el6.<arch>.rpm
• redhat-rpm-config-9.0.3-25.el6.noarch.rpm
• kernel-devel-2.6.32-71.el6.<arch>.rpm
• rpm-build-4.8.0-12.el6.<arch>.rpm
• gcc-4.4.4-13.el6.<arch>.rpm
• libuuid-2.17.2-6.el6.i686.rpm
• freetype-2.3.11-5.el6.i686.rpm
• libSM-1.1.0-7.1.el6.i686.rpm
• libICE-1.0.6-1.el6.i686.rpm
• libXi-1.3-3.el6.i686.rpm
• libX11-1.3-2.el6.i686.rpm
• libXext-1.1-3.el6.i686.rpm
• libXcb-1.5-1.el6.i686.rpm
• libXau-1.0.5-1.el6.i686.rpm
• libXrender-0.9.5-1.el6.i686.rpm
• libXrandr-1.3.0-4.el6.i686.rpm
• libXfixes-4.0.4-1.el6.i686.rpm
Configuring SMI-S providers 37