Setting up HP SIM 5.x on an HP-UX Serviceguard Cluster (448492-002, January 2009)

# failure, this permits the cluster software to switch LANs locally

# (transfer to a standby LAN card). Adjust as necessary.

# LOCAL_LAN_FAILOVER_ALLOWED replaces obsolete NET_SWITCHING_ENABLED.

LOCAL_LAN_FAILOVER_ALLOWED YES

# Enter the value for NODE_FAIL_FAST_ENABLED.

# Possible values are YES and NO.

# The default for NODE_FAIL_FAST_ENABLED is NO. If set to YES,

# in the event of a failure, the cluster software will halt the node

# on which the package is running. All SYSTEM_MULTI_NODE packages must

have

# NODE_FAIL_FAST_ENABLED set to YES. Adjust as necessary.

NODE_FAIL_FAST_ENABLED NO

# Enter the complete path for the run and halt scripts. In most cases

# the run script and halt script specified here will be the same script,

# the package control script generated by the cmmakepkg command. This

# control script handles the run(ning) and halt(ing) of the package.

# Enter the timeout, specified in seconds, for the run and halt scripts.

# If the script has not completed by the specified timeout value,

# it will be terminated. The default for each script timeout is

# NO_TIMEOUT. Adjust the timeouts as necessary to permit full

# execution of each script.

# Note: The HALT_SCRIPT_TIMEOUT should be greater than the sum of

# all SERVICE_HALT_TIMEOUT values specified for all services.

# The file where the output of the scripts is logged can be specified

# via the SCRIPT_LOG_FILE parameter. If not set, script output is sent

# to a file named by appending '.log' to the script path.

#SCRIPT_LOG_FILE

RUN_SCRIPT /etc/cmcluster/hpsim/hpsim.cntl

RUN_SCRIPT_TIMEOUT NO_TIMEOUT

HALT_SCRIPT /etc/cmcluster/hpsim/hpsim.cntl

HALT_SCRIPT_TIMEOUT NO_TIMEOUT

# Enter the names of the storage groups configured for this package.

# Repeat this line as necessary for additional storage groups.

# Storage groups are only used with CVM disk groups. Neither

# VxVM disk groups or LVM volume groups should be listed here.

# By specifying a CVM disk group with the STORAGE_GROUP keyword

# this package will not run until the CVM system multi node package is

# running and thus the CVM shared disk groups are ready for

# activation.

# NOTE: Should only be used by applications provided by

# Hewlett-Packard.

# Example : STORAGE_GROUP dg01

# STORAGE_GROUP dg02

# STORAGE_GROUP dg03

# STORAGE_GROUP dg04